Removes Sealers and Toned Finishes

PowerLift is a powerful liquid remover formulated to lift old stains and finishes from decks, fences, siding, and other exterior woods. It also effectively removes dirt and gray from weathered, unfinished exterior woods. PowerLift can also be used to reduce mill glaze, the hard, shiny surface film found on new wood.

Where To Use
• For use on decks, fences, siding and other exterior woods.
• To remove previous finishes and build-up from decks.
• To remove dirt and gray from weathered exterior woods.
• For exterior use only.

Preparation
• PowerLift is very slippery. Take special care when walking.
• Cover any adjacent areas you do not wish to clean. Thoroughly wet plants and shrubs.
• Wear eye protection and rubber gloves.

Application
• Do not dilute.
• Do not apply in direct sunlight.
• Apply a uniform coat of PowerLift with garden sprayer, brush or roller over an area you can work with in 10-15 minutes.
• Allow PowerLift to remain wet on the surface for 10-15 minutes.
• When finish or dirt begins to lift from the wood surface, scrub as needed with a stiff bristle brush (do not use a wire brush).
• Rinse with large amounts of fresh water, using the highest pressure from water source.  Or use a pressure washer at 500 to 1000 psi.
• If stubborn areas remain, repeat the application in those areas.

Dry Time
• Allow wood to dry thoroughly (2-3 warm, dry days minimum) before refinishing.

Clean Up
• Clean tools with soap and water.


LIMITED WARRANTY - PowerLift® Deck Sealer Remover

Product Safety Information