Formulated For Unsurpassed Durability And Protection

TWF-SEMI Semi-Transparent Wood Finish is a premium quality finish that protects and restores the natural beauty of wood from moisture and UV. Lightly pigmented, it provides a classic oil look that allows a surface's subtle colors, natural grains and textures to shine through. The TWF-SEMI Semi-Transparent Wood Finish is fortified with Penetrol® for deep penetration and unmatched adhesion on both new and weathered surfaces.

Available In
• Available in one neutral tint base and 24 custom tints with universal colorants.

Where To Use
• Ideal for use on decks, siding, fences, shakes, shingles, docks, doors, barns, beams, rafters, trim boards, outdoor wooden furniture or any exterior wood surface.

Preparation
• Surfaces to be coated should be clean and dry before applying TWF-SEMI Semi-Transparent Wood Finish.
• Sand, scrape or wire brush to remove all loose flaking or peeling finish.
• Pressure wash to remove excess dirt and other contamination.
• When using chemical cleaners, follow manufacturer’s directions.
• Mildew – A mildew-resisting component has been added to this product to make it dry film mildew resistant, however, no coating is mildew proof. Before coating, be sure to remove any mildew.
• Allow 2-3 days dry time after cleaning wood surface before finishing.
• If the wood surface is new, prepare the surface with Flood® Wood Stripper to reduce mill glaze and other factory applied sealers. This will open up the wood and allow maximum penetration.

Application
• Cover everything you do not wish to coat.
• Do not apply if cold, wet weather is expected within 48 hours.
• Apply with a synthetic brush, roller, stain brush/pad or airless spray (.011-.015 fluid tip/1200-1800 psi).
• Mix thoroughly before and periodically during application.
• Apply an even coat of TWF-SEMI Semi-Transparent Wood Finish, avoiding heavy application.
• When spraying, always backbrush or backroll material to provide maximum substrate wetting, penetration and uniform appearance.
• During application if it is necessary to switch from one can to another, stop at natural breaks such as corners.

Dry Time
• 24-48 hours (77°F and 50% relative humidity)
• Maximum cure and dry time may be prolonged when highly humid or damp, cool conditions prevail.

Clean Up
• Clean brushes and tools with mineral spirits.
• Danger:  Rags, steel wool or waste soaked with this product may spontaneously catch fire if improperly discarded.  Immediately after use, place rags, steel wool and waste in a tightly sealed, water-filled container.


LIMITED WARRANTY - Flood® TWF-SEMI Semi-Transparent Wood Finish

Product Safety Information